Moulding Technique

Hair Dryer

1. Mould one shin pad at a time!.
2. Place the shin pad on a clean & flat surface.
3. Heat the shin pad for 3 to 4 mintues with a hair dryer. (medium/high heat from a reasonable distance)
4. Let the shin pad cool slightly for 10 to 15 seconds.
5. Place the slightly cooled shin pad against your shin and hold there for a few minutes.
6. When the shin pad is fully cooled you can add the eva layer to the back of the shin pad.
7. Cut off any over hanging eva.
8. You are ready to go!